Installing The Battery Pack; Insert Battery - JVC GR-DV1 Manuel

All manuals and user guides at all-guides.com
NOTES:
If you connect the camcorder's DC cord to the
adapter during battery charging, power is
supplied to the camcorder and charging stops.
When using the AC Power Adapter/Charger, be
sure to use the supplied power cord only.
The AC Power Adapter/Charger is for use with the
BN-V712U Battery Pack only.
When charging the Battery Pack for the first time
or after a long storage period, the Charge
Indicator may not light. In this case, remove the
Battery Pack from the AC Power Adapter/Charger,
then try charging again.
Since the AC Power Adapter/Charger processes
electricity internally, it becomes warm during use.
Be sure to use it only in well-ventilated areas.
Be sure to securely connect the power cord to the
AC Power Adapter/Charger.
Before connecting to an AC outlet, connect the
power cord to the AC Power Adapter/Charger. If
you plug into an AC outlet first and the power
cord's terminal comes in contact with a metal
surface or object, there is the possibility of a short
circuit or fire.
** Charging Environment
Perform charging where the temperature is between
10° and 30°C. (20°–25°C is the ideal temperature
range for charging.) If the environment is too cold,
charging may be incomplete.
Continuous Shooting
Continuous shooting is possible for approximately
30 minutes, under the following conditions:
• A BN-V712U Battery Pack is in use
• The temperature is approximately 20°C/68°F
However, . . .
• If the temperature is below 10°C/50°F, or
• If Zoom or RECORD/STANDBY are engaged
repeatedly, continuous shooting capability is
reduced significantly. Before extended use, it is
recommended that you prepare enough battery
packs to cover 3 times the planned shooting time.

Installing The Battery Pack

The battery pack does not charge while in the
camcorder. Before installation, make sure the
battery pack has been charged fully.
BATTERY COVER
1 OPEN BATTERY COVER
Move the cover in the direction of the arrow.
2

INSERT BATTERY

Remove its protective cap and insert the + –
end of the battery first.
3 CLOSE BATTERY COVER
NOTE:
To remove a discharged battery pack, simply open
the cover and slide the battery pack out.
11
BATTERY