SPORTSTECH FPR300 Manuel page 37

Step for Model FPR350 Pro
1. First, insert the rods into the large holes in the lattice frames (L / R) and screw them tight with ten
screws (1) and ten washers. Do not fully tighten the screws yet!
2. Attach the two frame extensions to the rung frame with four screws (6), eight washers and four nuts,
as shown, with the U-profiles pointing downwards.
3. Now place the rung ladder with frame extension on the front frame rails and the cross braces so that
you can attach them to the front vertical frame with four screws (8), eight washers and four nuts.
4. Use four flat connectors, eight screws (8), sixteen washers and eight nuts to fix the rear part of the
rung ladder to the cross brace of the main frame.
5. Finally, tighten all screws!
1 (10x) (M10x20)
6 (4x) (M10x65)
8 (8x) (M10x70)
4.
8
8
6
6
1
1
8
8
Firmly tighten all component parts
and pre-assembled parts!
37
2. 6
6
1.
3.
Frame extension
8
8
1
1
EN
8
8