Human Touch Perfect Chair Laptop Desk Mode D'emploi Et D'entretien page 8

Stowing the laptop desk
To stow the Laptop Desk, out of the way,
simply flip it over to the side of the chair.
Rotate the Laptop Desk to avoid interference
with the floor.
You can also quickly remove the laptop desk (minus the bracket) without completely uninstalling it.
1. Use the provided open wrench to remove the nut on the bottom of the mounting post.
2. Pull up on the Laptop Desk arm and mounting post to remove the unit from the chair.
The mounting bracket remains, for easy reinstallation.
Nut
Mounting bracket
Specifications*
Laptop Desk Size:
Laptop Desk Weight:
Maximum Load Weight:
*Specifications are subject to change without prior notice.
humantouch.com
Mounting bracket
18"L x 12"W
9 Lbs.
25 Lbs.
12
maintenance
After years of use, the table tilt and swivel tension screws may become loose and require tightening. Follow the steps in
this section carefully to perform this maintenance.
Adjusting the table tilt tension
1. Lift the Laptop Desk off the post, then turn it upside down.
2. Remove the Allen wrench from the storage slot on the bottom
of the Laptop Desk, then use it to slightly tighten the tilt screws.
IMPORTANT: Do not over-tighten the screws or the desk
may break. Be sure to tighten the two screws equally.
3. Test the tension to ensure that is appropriately tight, and that
the table tilts smoothly. If the table does not tilt smoothly, you
likely did not tighten the screws equally.
Adjusting the table swivel tension
1. Lift the desk off the post, then turn it upside down.
2. Remove the Allen wrench from the storage slot on the
bottom of the Laptop Desk, then use it to slightly tighten
the swivel screw.
Tension screws
Desk upside down
Swivel screw
Desk upside down
13