Human Touch Perfect Chair Laptop Desk Mode D'emploi Et D'entretien page 3

get ready
Unpack the box Unpack the box, including the inner box containing small parts. Make sure you
have each of the following items:
TOOLS HARDWARE
Allen wrench
Short screw (4)
Wrench
Long screw (2)
COMPONENTS
Mounting plate Mounting post
Spacer (5)
Post cap
Spacer plate
Remove the right-hand armrest and accessory table (if any)
1. Using the larger Allen wrench (provided), remove the four Allen screws from the underside of the right-hand
armrest (Fig.1).
2. Discard the screws; retain the washers.
3. Remove the armrest from the chair.
4. If you have a Perfect Chair accessory table attached to your chair, set it aside for later installation.
Larger Allen wrench
(Fig.1)
humantouch.com
ACCESSORIES
Edge stop (short) Edge stop (tall)
(2) (2)
Cable clip (2)
Laptop desk
Washer
Allen screw
2
Installing your Perfect Chair Laptop Desk is easy!
remove the armrest, install the mounting bracket, reinstall the
armrest, then quickly assemble the mounting post. Place your
Laptop Desk on top of the mounting post, and you're done!
Install the mounting bracket
1. Using the larger Allen wrench (provided), remove the two screws that secure the silver armrest plate to the top of the
armrest support (Fig.2)
(Fig.2)
2. Discard the screws; retain the washers.
3. Place the Laptop Desk mounting plate on top of the armrest support as shown, then place the silver armrest plate on
top of the bracket, aligning the holes (Fig.3).
(Fig.3)
Simply
Silver armrest plate
Silver armrest plate
Laptop Desk
mounting plate
3