Safety Note - Human Touch Perfect Chair Laptop Desk Mode D'emploi Et D'entretien

take a seat
1. Pull the desk out and to the side, out of the way (Fig.12).
2. Take a seat.
3. Pull the table back toward you to the desired location (Fig.12).
4. Recline or incline your chair to the desired location. NOTE: You can recline approximately two-thirds of the full recline
range (depending on the height at which you installed the desk) while using your Laptop Desk (Fig.13).
SAFETY NOTE: Should you inadvertently recline to a full recline position, the Laptop Desk will automatically rise to
avoid trapping your legs between the chair and the desk.
(Fig.13)
humantouch.com
(Fig.12)
8
Adjust the desk level
You can adjust your desk level up to two inches, to accommodate objects up to the maximum allowable 10 Lbs. at
a perfect level. For your safety, do not place any food or drink on the Laptop Desk.
1. While sitting in the chair, place the object you intend to use (laptop/iPad/book) on the desk. CAUTION: Do not place
any object that weighs more than 10 Lbs. on the desk, as permanent damage to the desk may occur.
2. Observe whether the desk needs to be raised or lowered to be level.
3. Lift the desk up slightly with one hand to relieve pressure on the leveling screw, then use your other hand to turn the
screw slightly clockwise to raise the desk or counterclockwise to lower it (Fig.14).
CAUTION: You must raise the desk before adjusting the leveling screw to avoid permanently damaging the desk.
NOTE: Do not remove the screw, as it is difficult to reinstall.
4. Repeat step 1-3 until the desk is level.
Tension screw
Leveling screw
Lift the desk up slightly to relieve
pressure on the leveling screw
(Fig.14)
9