Mounting The Hood - Zephyr Tornado Mini AK8400BS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

Mounting the Hood

CAUTION
At least two installers are required due to the weight
and size of the hood.
1. Install optional AK084xAS Stainless Steel Liner.
Review manual included with liner for more details.
2. If no liner is used, cut out an opening in bottom of
the cabinet by following the dimensions in FIG. B.
3. Remove aluminum mesh filter.
4. Lift Power Pack into opening and ensure locking
clip has locked into position. (Locking clip is located
on left side of Power Pack. FIG. C.
5. Fasten (2) #6 screws into the rear long side of Power
Pack. If a liner is used, the screws will go through
the Power Pack mounting holes, then the liner and
the wood base. NOTE: Wood blocking may need to
be added to cabinet base if additional support is
needed. See FIG. D and FIG. E.
6. Remove 4 screws from Power Pack face plate. The
face plate will drop down and hang by internal
chains. Access to front long side of Power Pack is
now available. Fasten (2) #6 screws into the front
long side of Power Pack.
7. Re-install Power Pack face plate by (4) previously
removed screws.
8. Install duct work and seal with duct tape and install
electrical.
9. Remove all packing materials before using Power
Pack. Switch power on and check for leaks around
duct tape. Install aluminum mesh filter.
Tornado Mini Use, Care, and Installation Guide
Installation Instructions
cabinet bottom cut-out size
wood base
locking clip
metal or other non
combustible material
wood base
2" minimum
secure (2) #6 screws to mounting
holes on each long side of Power Pack
19- "
3/4
FIG. B
Front View
Ductwork
mounting holes
FIG C
FIG. C
Right Side View
Ductwork
FIG. D
Power Pack
Stainless Steel Liner
FIG. E
13