Mounting Height, Clearance, & Ducting - Zephyr Tornado Mini AK8400BS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM
Mounting Height, Clearance, & Ducting
Min 20" - Max 36" (electric cooktops)
Min 24" - Max 36" (gas cooktops)
36"
It is important to install the hood at the proper mounting height. Hoods mounted too low could result
in heat damage and fire hazard; while hoods mounted too high will be hard to reach and will lose its
performance and efficiency.
If available, also refer range manufacturer's height clearance requirements and recommended hood
mounting height above range. Always check your local codes for any differences.
For shipment and installation damages:
Please fully inspect unit for damage before installation.
If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or
replacement.
If the unit is damaged by the customer, repair or replacement is the responsibility of the customer.
If the unit is damaged by the installer (if other than the customer), repair of replacement must be
made by arrangement between customer and installer.
Tornado Mini Use, Care, and Installation Guide
Installation Instructions
A minimum of 6" round or 3-1/4" x 10" rectangular duct must
be used to maintain maximum air flow efficiency.
Always use rigid type metal ducts only. Flexible ducts could
restrict air flow by up to 50%.
Also use the ducting calculation sheet (on page 8) to
compute total available duct run when using elbows,
transitions and caps.
ALWAYS, when possible, reduce the number or transitions
and turns. If long duct run is required, increase duct size.
If turns or transitions are required; install as far away from
hood duct output and as far apart, between the two as
possible.
Minimum mount height between range top to hood bottom
should be no less than 20" for electric cook tops and 24" for
gas cook tops.
Maximum mount height should be no higher than 36".
9