Oven Cleaning - Frigidaire PLCS389ECE Manuel

Oven Cleaning

Self-Clean Cycle Time Length
Nettoyage
The SPEED CLEAN
Speed
clean
planning to use the oven directly after a self-clean cycle remember to allow time for the oven to cool down and the oven
door to unlock. This normally takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours to
complete. *It is recommend to use a
Nettoyage
cycle (4 hour) for heavy soils (to assure satisfactory results).
Maxx
clean
NOTE: A smoke eliminator in the oven vent converts most of the soil into a colorless vapor.
During the Self-Cleaning cycle, the outside of the range can become very hot to touch. DO NOT leave small
children unattended near the appliance.
To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the
side of the oven when opening the door to allow hot air or steam to escape.
DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid
possible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be VERY HOT.
INSTRUCTIONS
To start an immediate Self-Cleaning cycle or to set a delay start time of 4:30 and shut of
automatically (example provided is a default 3 hour Self-Clean cycle):
1. Be sure the clock is set with the correct time of day, the oven is empty
and the oven door is closed.
Clean
2. Press . "CLEAN" will flash and "3:00" HR will show in the display
Nettoyer
(Figure 1). The control will automatically clean for a 3 hour period (default
self-cleaning cycle time). Note: If a 2 or 4 hour clean time is desired, press
Nettoyage
for 2 hour or press
Speed
clean
time based on the amount of soil: light, medium or heavy (* See above).
START
3. Press .The "DOOR LOCKED" icon will flash; "CLEAN" icon and
DÉPART
the letters "CLn" will remain on in the display (Figure 2).
4. As soon as the control is set, the motor driven oven door lock will begin
to close automatically. Once the door has been locked the "DOOR
LOCKED" indicator light will stop flashing and remain on. Also, the oven
icon will appear in the display (Figure 3).
Note: Allow about 15 seconds for the oven door lock to close.
NOTE: If the optional delay Self-Clean feature is needed, finish steps 5-7. If Self-Clean is started immediately
skip the remaining steps and continue with "When the Self-Clean cycle is done" on the following page.
Start time
5. Press . Enter the desired start time using the number pads
Heure
de
départ
(Figure 4).
0
3
START
6. Press . The "CLn" icon will turn off; "DELAY", "DOOR LOCKED"
DÉPART
and "CLEAN" icons will remain on (Figure 5).
7. The control will start the self-cleaning at the set start time, for the period of
time previously selected. At that time, the icon "DELAY" will go out; "CLn"
and oven icon will appear in the display (Figure 6).
Clean
, CLEAN and MAXX CLEAN
Nettoyer
Nettoyage
cycle (2 hour) for light soils, a
Speed
clean
Nettoyage
for a 4 hour clean time. Set the cleaning
Maxx
clean
Nettoyage
pads control the Self-Cleaning feature. If you are
Maxx
clean
Clean
cycle (3 hour) for average soils, and a
Nettoyer
PRESS
Clean
Nettoyer
Nettoyage
or
Speed
clean
START
DÉPART
Start time
4
Heure
départ
4
START
DÉPART
18
DISPLAY
Figure 1
Nettoyage
Maxx
clean
Figure 2
Figure 3
de
0
3
Figure 4
Figure 5
Figure 6