Valor 1595CFKV2 Guide D'installation Et D'operation page 5

6. Plug the fan power cord molex connector into the
control module marked "FAN".
7. Plug the 3-prong power cord into receptacle at the
right into the fireplace case.
Junction box in
lower right corner
of liner box
8. Use the self-adhesive wire clamp provided to secure
the cables to the base of the fireplace.
Apply label
Clean the area of sheet metal liner box base adjacent
to the fan, peel the self-adhesive backing from the label
provided with the kit and apply the label to the base.
BLOWER BLOWER
GROUND WIRE, BLOWER HOUSING
TO STUD ON MOUNTING PLATE
THERMAL SWITCH
JUNCTION BOX
WITHIN FIREPLACE
GND 3-PIN MOLEX
MODEL 1595CFKV2
POWER CORD,
CIRCULATING FAN KIT
37" LONG
120 VAC, 60HZ, LESS THAN 1 AMP
#4007877
MANUFACTURED BY
MILES INDUSTRIES LTD
NORTH VANCOUVER, CANADA
MOLEX
4007878-01
POWER CORD ASSEMBLY CONNECTORS
#4006350 SUPPLIED
NOTE - ALL WIRING IS SPECIFIC TO THIS KIT
SEPARATELY WITH FAN
AND SHOULD ONY BE REPLACED WITH
CONTROL MODULE
ORIGINAL EQUIPMENT WIRING FROM THE
MANUFACTURER.
FAN CONTROL MODULE
#4002530
(SUPPLIED SEPARATELY)
Apply label to
base next to fan
Reassemble the appliance
Reassemble the unit in reverse order and continue
with the heater installation following the installation
instructions supplied with the heater.
5