Valor 1595CFKV2 Guide D'installation Et D'operation page 3

Test fan
It may be desireable to test the fan operation before
reassembling the burner module and completing the
fireplace installation.
To test the fan operation the thermal switch can be
temporarily bypassed by connecting the power cord
lead directly to the fan motor (see diagram). Be careful
with wire terminals on motor, they are fragile. Unplug
the power cord from the control module before
bypassing the thermal switch. Following instructions
below, confirm fan operation with the thermal switch
bypassed then reconnect thermal switch.
Note: If desirable, the thermal switch may be left
permanently bypassed; however the fan may continue
to run when the burner shuts off but the control knob
has not yet rotated all the way down.
Operation with Valor 10 Remote Control
To operate the fan, press the
handset; the fan icon
the and buttons to set the fan speed. No bar
showing means the fan is OFF. Press the
confirm the setting or wait. The fan icon and number
of bars will show when the remote is in other modes
to confirm the fan status. There may be a delay if the
fireplace has just been turned on.
Note: When the heater is operated at lower settings,
the fan may cycle off and on repeatedly as the thermal
switch temperature cannot be maintained due to the
operation of the fan.
Remove wire from
switch and connect
directly to motor for
testing
button on the remote
flashes on the display. Press
button to
Install fan
To gain access to the fan area
1. Detach the burner (3 screws).
2. Slide the burner right to disengage it from the orifice
and lift it straight out of the firebox.
3. Remove the middle burner mount (2 screws).
4. Detach the burner module plate (10 screws).
Burner module plate
5. Rotate the rear edge of the burner module upwards
and remove the module plate from the firebox
being careful not to damage the pipes and other
parts attached underneath the plate.
To install the fan
1. Insert the fan through the opening in the floor of the
firebox and rotate into position.
Insert fan and rotate into position
Middle
burner
mount
3