Dynamic Heat Control™ Installation - Napoleon DYNAMIC HEAT CONTROL Manuel D'installation

Masquer les pouces Voir aussi pour DYNAMIC HEAT CONTROL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Dynamic Heat Control™ installation
4.0 Dynamic Heat Control™ installation
EN
Before starting the Dynamic Heat Control™ installation, remove the barrier. Refer to the appliance installation
manual.
note:
The shipping brackets must only be removed from the header shield if the enclosure is
recessed.
1. Remove fasteners securing header shield. Do not discard fasteners.
2. Once the header shield is removed, replace the 4 screws removed in step 1.
10
W415-2753 / 10.23.19
Shipping brackets
Header
shield

Publicité

Chapitres

Table des Matières
loading

Table des Matières