Relative Mode; Backlighting; Hold; Auto Power Off - Multimetrix DMM 210 Notice De Fonctionnement

2. Press the MAX/MIN key again to display the "MIN" icon. The
multimeter will display and hold the minimum measurement until a
new minimum value is measured.
3. To exit MAX/MIN mode press and hold the MAX/MIN key for 2
seconds.

3.11 Relative mode

Relative mode enables relative measurement results to be obtained in
relation to a stored reference value. The displayed value is the
difference between the stored reference value and the value measured.
1. Perform the measurement as described in the operating
instructions.
2. Press the REL button to store the displayed measurement. The
"REL" indicator is displayed.
3. The display will now indicate the difference between the stored
reference value and the value measured.
4. Press the REL button to exit relative mode.
 Relative mode does not apply to frequency measurements.

3.12 Backlighting

Press and hold down the HOLD key for >1 second to turn on or off
the screen's backlighting. The backlighting will automatically turn off
after 10 seconds.

3.13 HOLD

The hold function freezes display of the current value. Briefly press
the HOLD key to activate or disable the HOLD function.

3.14 Auto power OFF

The auto off function turns off the multimeter after 15 minutes. To
disable this function, hold down the MODE button when turning on
the multimeter.

3.15 Low battery indication

The icon will appear in the lower left corner of the screen when the
battery voltage becomes low. Replace the battery when this icon is
displayed.
26
Chapter II
DMM210