Dc Current Measurements - Multimetrix DMM 210 Notice De Fonctionnement

1. Set the function switch to the VAC/Hz/%
position.
2. Insert the black test lead banana plug into the
negative COM terminal. Insert red test lead
banana plug into the positive + jack.
3. Apply the test probes to the points of the circuit
to be tested
4. The voltage measured is displayed on screen
5. Press the Hz % button to display "Hz".
6. The frequency measured is displayed on screen.
7. Press the Hz % button again to display "%".
8. The duty cycle is displayed in percentage

3.3 DC current measurements

 Do not make 20 A current measurements for longer than 30 s.
Exceeding 30 seconds may cause damage to the meter and/or
the test leads.
1. Insert the black test lead banana plug into the
negative COM terminal.
2. For DC current measurements up to 6000µA, set
the function switch to the µA position and insert
the red test lead banana plug into the µA/mA
terminal.
3. For DC current measurements up to 600mA, set
the function switch to the mA position and insert
the red test lead banana plug into the µA/mA
terminal.
4. For DC current measurements up to 20A, set the
function switch to the 10A position and insert the
red test lead banana plug into the 10A terminal.
5. Press the MODE button to display "DC" on screen.
6. Remove power from the circuit to be tested, then open the circuit at
the point where you wish to measure the current.
7. Apply the test probes to the points of the circuit to be tested.
8. Apply power to the circuit.
9. The current measured is displayed on screen
22
Chapter II
DMM210