Operation; Cleaning; Storage - Profi Cook PC-UM 1113 Mode D'emploi

All manuals and user guides at all-guides.com

Operation

Preparation
1. Ensure that the function switch is in the "0" position.
2. Place the mixing vessel in position.
3. Now put the ingredients that are to be mixed into the
mixing vessel.
4. Put the lid on.
5. Close the refill opening with the cap.
Mixing
Operation is carried out with the setting control:
Level 0 = off
Level 1 = low rpm
Level 2 = high rpm
P = high speed in pulse mode
WARNING:
• Always remove the plug before cleaning.
• Do not immerse the motor housing in water for cleaning in any
case. Otherwise this might result in an electric shock or fire.
• The blades on the knife block are very sharp. A risk of injury exists!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The individual parts are not dishwasher-safe.
NOTE: Preliminary Cleaning
Half fill the mixing vessel with water and turn the switch to
"P" for approximately 10 seconds. Then pour out the liquid.
Motor Housing
Clean the housing only with a damp cloth and a squirt of
washing-up liquid. Dry with a cloth.
Knife Block
For this, also refer to figure "A" on page 3.
Removal:
1. Turn the mixing vessel on its head.
2. Use moderate force to screw off the locking ring of the
blade unit by turning it towards the UNLOCK marking.
3. Take the knife block carefully out of the mixing vessel.
CAUTION:
The seal ring cannot be removed!
PC-UM 1113_IM
Adding Further Ingredients to be Mixed
Items to be mixed or spices can be fed in through the filling
aperture.
• Please switch off the machine before doing so.
• Before you switch the device on again, close the opening.
Stopping Operation
1. Turn the switch to the position "0".
2. Wait until the knife has stopped.
3. Disconnect the mains plug from the wall socket.
4. Remove the mixing vessel. Turn it anticlockwise.
5. Take off the lid before pouring.
IMPORTANT NOTE:
Citrus juices and food containing acids should never be
stored in metal vessels.

Cleaning

Installation:
1. Place the blade unit onto the seal ring.
2. Insert the locking ring and tighten it by turning it towards
the LOCK marking.
3. Ensure that the knife block sits securely in position.
Mixing Jar, Lid, Measuring Cup, Locking Ring and Blade
Unit
Clean these parts in a bowl of hot water. Then dry everything
before assembling the parts again.
• Clean the device as described. Let the accessories dry
completely.
• You may wind the mains cable at the bottom of the ap-
pliance.
• We recommend that you store the device in its original
packaging when it is not to be used for a longer period.
• Always store the device at a well ventilated and dry place
outside the reach of children.

Storage

22.11.16
33