Operation - Profi Cook PC-SMS 1226 Mode D'emploi

• For best results with the whisk, use high-walled and not
too large containers.
• If the maximum speed is too slow, stop the process.
Reduce the amount of food being blended. Loosen up
solid food.
Table
Accessories Function
For mixing and stirring shakes, drinks,
sauces; for puréeing soups and sauces; for
Blending rod (6)
chopping pre-cut, solid foods, dips, baby
food.
For whipping cream, beaten egg whites,
puddings; for whipping sauces, sponge
Whisk (9)
cake dough and other fluffy, foamy foods,
omelette dough, mayonnaise.
Assembly / Disassembly
For assembly, also refer to the figures on page 3.
Attach the Blending Rod (Fig. A)
1. Place the motor housing (5) on the blending rod (6).
2. Turn the motor housing clockwise as far as it will go. The
symbols and must be on top of each other. Check
that they are firmly seated.
Remove Blending Rod
Remove the blending rod from the motor housing by briefly
turning it anticlockwise.
Whisk (Fig. B)
If you want to use the whisk (9), replace the blending rod
with the adapter (8).
1. Engage the whisk in the drive shaft of the adapter by
applying moderate pressure.
2. Place the motor housing (5) on the adapter (8).
3. Turn the motor housing clockwise as far as it will go. The
symbols and must be on top of each other. Check
that they are firmly seated.
Electrical Connection
1. Check that the mains voltage you want to use matches
that of the appliance. You will find the information on the
type plate.
2. Insert the mains plug into a properly installed protective
contact socket.
PC-SMS1226_IM
• Short-time operation: Observe the maximum operating
time of the accessories in the table below. Let the appli-
ance cool down for about 1 minute before using it again.
Select the accessories according to the table below.
Speed
TURBO button
button
Steplessly Maximum speed.
selectable It is not adjustable.
Steplessly Maximum speed.
selectable It is not adjustable.

Operation

1. Immerse the entire blender head in the foodstuff or
beverage. Hold the appliance vertically. This way you
avoid splashes.
2. Hold the handle with one hand in such a way that you
can press the push button (3). With the other hand you
can adjust the speed with the controller (2).
- You achieve a pulse mode by pressing and releasing
the push button in intervals.
- Press the TURBO button to reach the highest speed.
End Operation
• The appliance switches off when you release the push
button.
WARNING: Risk of Injury!
The motor continues to run briefly. Wait for the
mounted accessory to come to a standstill.
• Pull out the mains plug from the socket after use.
Operating time
Maximum 1 min-
ute
Maximum 4 min-
utes
9
29.11.21