Shindaiwa HomePro 22T Manuel D'utilisation page 7

Assembly and Adjustments
22T Cutting Attachment Shield Installation
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Retaining
Nut
1025
Figure 8
Install the Cutting Attachment Shield.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
See Figure 8.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting
attachment shield mounting plate.
Assembly
Trimmer Head Installation
1. Position the trimmer with the gearcase
output shaft pointing up; as shown in
the illustration.
. Install the spacer onto the
output shaft.
3. Install the tool holder and align the
hole on the side of the holder with the
notch on the gearcase; as shown in the
illustration.
4. Insert a 4 mm hex wrench through the
tool holder hole and the gearcase notch
to lock the tool holder to
the gearcase.
5. While holding the tool holder locked
with the 4 mm hex wrench, thread the
trimmer head onto the
output shaft.
6. Remove the hex wrench to unlock the
tool holder. Rotate the trimmer head by
hand to ensure that it does not bind and
rotates freely.
Outer
Tube
Line Cutter
Shim
Cutting
Attachment
Mounting
Hex
Plate
Screws
Figure 8A
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
See Figure 8.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket head
cap screws.
Spacer
Figure 9
WARNING!
A standard grass trimmer
with a loop handle should NEVER be
operated with blade-type attachments.
without the cutting attachment shield
installed and tightly secured!
Cutting
Attachment
The line cutter can be positioned in
Shield
 positions to obtain different line length
for cutting.
Nuts
Wear gloves to protect your hands
when handling.
To Change Position of Line Cutter.
1. Remove the  hex screws with a 4mm
. Rotate line cutter. See Figure 8A.
3. Reinstall the two hex screws and tighten
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are
not captured.
Tool Holder
Output
Shaft
Gearcase Notch
WARNING!
NEVER operate the 22T
WARNING!
The line cutter is very sharp.
hex wrench. See Figure 8A.
them securely.
NOTE:
Install Trimmer Head
COUNTER CLOCKWISE (22T),
CLOCKWISE (22F)
7