Haussmann CK104-CS Manuel De L'utilisateur page 21

!
PROTRACTOR
ADJUSTABLE WRENCH
Fig.2
!
Fig.3
Fig.4
ASSEMBLY
WARNING! DO NOT connect the Cut-off saw to the AC power source until
the receptacle is properly grounded. It is not recommended that an extension cord
be used, but if one is necessary, follow the instructions below.
The 14" Cut-off saw comes pre-assembled from the factory.
TOOLS REQUIRED FOR ASSEMBLY (Fig.2)
The tools, pictured, are not included with this tool. It is highly recommended that the
14" cut-off saw be securely mounted to a tool stand. This is to prevent excessive
vibration during use. Mount the cut-off saw to the tool stand by:
1. Most tool stands have pre-drilled holes to accommodate a variety of tools.
2. If the tool stand does not have an exact match for the holes, try to align the tool
base with as many pre-drilled holes as possible. Mark and drill new holes for
mounts that have missing holes.
3. Insert four 1/4" X 20 screws and washers through the underside of the tool stand
and up through the rubber feet on the base of the cut-off saw. The length of the
screws should be 1" (25 mm).
4. Tighten the screws securely.
UNLOCKING THE CUT-OFF SAW
WARNING! Disconnect the abrasive cut-off saw from the AC power source
eliminating any accidental starting of the motor.
TO CARRY THE CUT-OFF SAW: (See Fig.3)
Fold down head to base and catch the chain to lock head.
TO UNLOCK THE CUT-OFF SAW: (See Fig.4)
To unlock tool and raise head, please unlock the chain.
21