Motor Care - Garland Master Serie Manuel D'installation, D'utilisation Et D'entretien

MOTOR CARE

The motor on your convection oven is maintenance free since
it is constructed with self-lubricating sealed ball bearings.
It is designed to provide durable service when treated with
ordinary care. We have a few suggestions to follow on the
care of your motor. When the motor is operating, it cools
itself internally by air entering at the rear of the motor case,
provided proper clearance has been allowed.
Since the blower wheel is in the oven cavity it is at the same
temperature as the oven. If the motor is stopped while the
oven is hot, the heat from the blower wheel is conducted
down the shaft and into the armature of the motor. This
action could shorten the life of the motor.
We recommend, at the end of the bake or roasting period,
when the oven will be idle for any period of time, or before
shutting down completely, that the doors be left open
slightly. On the 400 series controllers press the COOL DOWN
key on the control panel. The fan will continue to run until the
oven cools down to 150°F (66°C).
22
At the end of the day, press the ON/OFF key, for the 400 series
controllers to activate the Auto Cool Down feature. The fan
will run on high until the oven cavity drops below 150°F
(66°C). During this time the "AUTO COOL DOWN" LED will
light. When the oven temperature drops below 150°F (66°C)
the oven turns off . This feature protects the oven motor from
pre-mature failure. On the 200 series controllers, push the
rocker switch to COOL position. Once cool set the rocker
switch to OFF.
NOTE: Optimal cool-down will be achieved with the door
open slightly.
Part Number 1955200 rev 7 4/15