Blower Wheel & Temperature Probe; Motor Care - Garland Master Serie Manuel D'installation, D'utilisation Et D'entretien

INSTALLATION/OPERATION MANUAL
MAINTENANCE & TROUBLESHOOTING
Blower Wheel & Temperature Probe
Tools: brush, cloth.
1. Unplug the unit from the receptacle.
2. Remove the racks, right rack guide and the baffl e.
3. Brush the wheel as needed to remove any grease and/
or particles.
4. Carefully wipe the blower wheel and temp probe clean
with a damp cloth.
5. Replace the baffl e, rack guide and racks.
Procedure is complete.
rev F 07/2017
Part Number: 4516833
GARLAND HALF SIZE ELECTRIC CONVECTION OVEN MODEL:MCOE5L

Motor Care

The motor on your convection oven is maintenance free
since it is constructed with self-lubricating sealed ball
bearings. It is designed to provide durable service when
treated with ordinary care.
We have a few suggestions to follow on the care of
your motor. When the motor is operating, it cools itself
internally by air entering at the rear of the motor case,
provided proper clearance has been allowed. Since
the blower wheel is in the oven cavity it is at the same
temperature as the oven. If the motor is stopped while the
oven is hot, the heat from the blower wheel is conducted
down the shaft and into the armature of the motor. This
action could shorten the life of the motor.
We recommend, at the end of the bake or roasting period,
when the oven will be idle for any period of time, or before
shutting down completely, that the doors be left open
slightly, and press the VIEW/UTILITY button on the control
panel. The fan will continue to run until the oven cools
down to 150°F (66°C). When the oven temperature drops
below 150ºF (66ºC) turn the oven off using the ON/OFF
switch. This feature protects the oven motor from pre-
mature failure. Optimal cool-down will be achieved with
the door open slightly.
Page 15