Programming Product Keys (Master 475) - Garland Master Serie Manuel D'installation, D'utilisation Et D'entretien

OPERATION Continued
10. Press SET key - ready to cook
11. Press START/CANCEL to begin manual cooking

Programming Product Keys (Master 475)

NOTE: Cooking time(s) is the element of the program that tells
the controller that other information (temperature, fan speed,
etc.) will be inputted into the controller. The fi rst step is to
enter all the time periods required, followed by the addition
of the other cooking elements.
1. Press and hold PROG key for three (3) seconds - all the
product key LEDs light.
2. CODE will be displayed. The controller is asking for the
access code. Press 4-2-7-5 and the START/CANCEL key.
PROD will be displayed indicating you have gained access
to Product Programming.
3. Press the product key (1 - 9) into which you want to store
a cooking program. SHLF will be displayed. The control is
asking if you want to program the key as a shelf timer or
with a cooking profi le. Select your answer by pressing the
START/CANCEL key. When the correct answer is displayed,
press the SET key. The TIME LED will light. 30:00 will be
displayed.
4. Set fi rst cook time using dial. If more than one cooking
profi le is desired:
• press the product key where the program is to be
stored (1 - 9) - PR-2 will be displayed.
• set the second cook time using the dial (factory
presets for PR-2 through PR-5 are :00).
• press the same product key (1 - 9) again - PR-3 will be
displayed.
• Repeat this process for all profi les. When the last
profi le time has been entered, press the SET key, OR
If less than fi ve (5) profi les are desired press the SET key
after the last required profi le - PRE will be displayed,
followed by :00. The controller is asking if you would like a
reminder alarm (pre-alarm) to sound during the cooking
process. (factory preset is :00)
5. If a pre-alarm signal is desired - dial in the time that
the alarm is to sound. (Ex. If the product is to be turned
halfway through the 60 minute cooking cycle, set the
pre-alarm to 30 minutes). If pre-alarm is not desired verify
that ":00" is displayed. Press the SET key - TEMP Led will
light, and the display will show the fi rst profi le cooking
temperature. (factory preset at 350°F)
6. Set the fi rst cooking temperature using the dial.
Part Number 1955200 rev 7 4/15 15