Important Information - elco Variatron K1,5MT VECTRON G 05.700 DUO PLUS Notice D'emploi

Table of contents
General information
Description
Table of contents
General information....................9
Important information....................9
Description...............................9-10
Assembly ...................................11
Functions and settings
of Altivar 11 ...........................12-13
Maintenance, troubleshotting......14
Notes ..........................................27

Important information

This document is intended to guide
personal qualified in the installation of
products such as speed controllers.
Installation and startup must be performed
by a qualified and authorized technician,
in accordance with trade practices.
Both the applicable regulations and the
instructions given in this manual must
be fully complied with. Any failure -
even partial - to observe these provisions
shall absolve the manufacturer from
any liability.
10
Safety of material and personal
Shut off power supply.
A incorrectly applied or installed
controller can result in component
damage or reduction in product life.
Failure to do so may result in personal
injury or death.
Electrical connection
The speed drive must be wired according
to delivered electrical diagram.
Installation protection and earthing must
comply with applicable regulations.
06/2005 - Art. Nr. 13 019 652A
Description
The K1,5MT kit contains:
the 1.5kW speed drive and its user
-
instructions,
the regulator's metal support,
-
2 switches and theirs supports,
-
an output potentiometer,
-
3 electrical wiring bundles,
-
three M5 x12 screws (for fastening
-
the support onto the burner),
four M5 x16 screws (for fastening
-
the speed drive onto the support),
3 cable grommets,
-
3 wires,
-
10 wiring straps,
-
1 wiring diagram,
-
1 set of speed drive assembly
-
instructions.
EN