Sime NATURAL S 160 Mode D'emploi page 25

STEP 12
STEP 10
10. Place and tighten the Ø22 mechanically tightened plug on the top right and on the bottom left of the collector/
collectors*. Place the water storage tank on the base with its electrical components to the left, when viewing
the water storage tank from the front.
11. Center the water storage tank's position on the collector/s. Rotate the water storage tank (if necessary) in order
for the cold and hot domestic water sockets to remain vertical to the horizontal surface.Ensure the appliance is
not tilted and is properly levelled. It is necessary to use a level.
12. Place the small flexible tube on the special connection 3/4" x DN16 INOX at the water storage tank's side
where the heating element is located and to the socket marked "collector intake".
13. Join the other end to the top left socket of the collector using the Ø22xDN16 INOX corner fitting*, having firstly
passed the tube through the insulation pipe.
14. Place the Τ-piece with the filling valve to the socket on the right side of the water storage tank marked
"collector return". Place the big flexible tube with the special connection to the T-piece on the right side of the
water storage tank.
15.
Place the other end at the bottom right socket of the collector using the Ø22 x DN16 INOX corner fitting*,
having firstly passed the tube through the insulation tube. Tighten all unions in the system as well as all the
screws on the base. Do the hydraulic connection, fill the closed loop and do the electrical connection as
described in the relevant sections. Check for leaks.
16. After having placed the collectors at a parallel to each other position, fasten them to the support base
tightening the fixing washers 8.
*
Use two wrench keys in order to avoid the copper tube mechanical strain.
All manuals and user guides at all-guides.com
ENG
STEP 14
STEP 15
*
25
SIME NATURAL S (vers. LP)