GRAUPNER Micro Star 190SX Manuel D'utilisation page 19

6. Basic Settings
• Degree of reaction (user level) - Dual Rate
Depending on your past experience, the response of the helicopter control commands can
be programmed in two stages: beginner or advanced. In beginner mode, the servo move-
ment can be reduced to 70% so that the helicopter is much easier to control. In advanced
mode, however the full travel is used, the helicopter reacts more directly, but is also more
diffi cult to fl y.
To learn how to control the helicopter easier, you should always start with the beginner
mode. Later, when you have experience, you can switch to the advanced mode.
After switching on the helicopter is always in the advanced mode. To switch between mo-
des, simply press the left control lever. An acoustic signal (a short beep for advanced and
two short beeps for beginners mode) confi rm the programming. You also see the reduced
travel immediately in the transmitter display, as shown:
Beginner:
Trim function
• Throttle
if the rotor should starts, even though you have not moved the throttle lever from the lower
position, or on the contrary, you move the throttle lever up , but the rotor didn't move, you
must adjust the throttle trim. Press the button to the left or right of the throttle stick. Do not
move the throttle stick from lower position, but the rotor is already moving, press the bottom
button until the rotor stops - or in other case the upper.
• Yaw
if the helicopter rotates already in place, although the control lever is still in the middle posi-
tion, press the trim button below the lever. If the helicopter rotates to the right, press the left
button until the helicopter stops. Accordingly, when turning left the right button.
• Direction
As long as you leave the control lever in neutral position, the helicopters must remain in a
stable position in the air. However, it moves e.g. forward or sideways, this can be corrected
with the direction trim.
If the helicopter moves forward, press the rear button to the left or right of the control lever
until the helicopter stops - or vice versa. If the helicopter moves to the right, press the left
button below the control lever until it stops - or vice versa.
Manual Micro Star 190
Advanced:
18