Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
After a fl ying session
•
At the end of a fl ying session the model should be replaced in its original packaging to avoid
the danger of accidentally bending or distorting the rotors.
•
If you know you will not be fl ying the helicopter for a long period, ensure that the model is
switched off, and remove the dry cells from the transmitter.
10. Care and maintenance
•
Clean the model carefully after every fl ying session.
•
The model and the remote control system components should only be cleaned using suita-
ble materials.
Please ask your local model shop for advice on this.
11. Assembly (and repair instructions)
If you have to use solvent-based adhesives, use them only in a well-ventilated room. Take was-
te adhesives and paints to your nearest toxic waste collection point. An unobstructed work area
of generous size is very helpful for all types of modelling activity.
Do not fl y the model outdoors if there is any wind.
We wish you loads of fun and pleasure fl ying your Micro Star 190 Helikopter!
12. Trouble Shooting
Problem
Rotor don't move
Rotor stops suddenly
The
helicopter
does
not react to the remote
control
The helicopter is hard
to control
21
The motors become quite hot during a
fl ight, and remain so afterwards. Don't
touch the motors until they have had
a chance to cool down to room tem-
perature.
Motor too hot!
Cause
•
Helicopter battery not connected
•
Weak helicopter battery
•
Transmitter switched OFF
•
Weak helicopter battery, ESC
shuts off for safety reasons
•
Transmitter - helicopter not con-
nected (bound)
•
Transmitter batteries weak
•
Trim (direction, yaw) not correct
•
Main blades damaged
Solution
•
Connect battery
•
Re-charge battery pack
•
Switch ON helicopter
•
Re-charge battery pack
•
Bind transmitter and helicopter, see
chapter 4
•
Change transmitter batteries
•
Check the trim, see chapter 6
•
Change main blades
Manual Micro Star 190
Publicité
Table des Matières
