Fitting The Display - Waeco MagicSpeed HUD Instructions De Montage Et De Service

MagicSpeed HUD
All manuals and user guides at all-guides.com
6

Fitting the display

6.1 Fitting the display
Warning!
Select the location of the display so that it cannot injure the passengers in
the vehicle under any circumstances (e. g. sudden braking, road traffic
accidents).
Observe the following installation instructions:
Select an installation location on the dashboard do that the display can be visibly
projected onto the front windscreen.
Never install the display in an area where your head could knock against it or in
the air bag deployment path. This could cause injury if the airbag opens.
The projection screen may not impair your vision when driving.
Make sure the connection cable is long enough.
To perform the installation, proceed as follows:
➤
Select a suitable installation location for the display (fig. 5 1, page 4).
➤
Fasten the display to the dashboard with the velcro strips (fig. 6, page 5).
➤
Clean the inside of the windscreen.
➤
Select a suitable installation location for the projection screen (fig. 5 2,
page 4).
➤
Spray a little water on the windscreen.
➤
Remove the protective foil from the projection screen.
➤
Fasten the projection screen to the windscreen (fig. 7, page 5).
➤
Smooth the projection screen so that there are no bubbles to impair the display.
6.2 Connecting the display electrically
Observe the following instructions when laying the connection cable:
Note
Where possible, use existing ducts or other bushings for the cable. If there
are no existing openings, you must drill a hole with an 8 mm diameter.
Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig. 1, page 3).
Note
Cables and connections which are not properly installed will cause
malfunctions or damage to components. Correct installation of cables and
connections ensures lasting and trouble-free operation of the retrofitted
components.
Fitting the display
21