Technical Description; Function Description; Operating Elements; General Information On The Electrical Connections - Waeco MOBITRONIC M170L Instructions De Montage Et De Service

_M170L.book Seite 30 Mittwoch, 20. August 2008 12:08 12

Technical description

5 Technical description
The M170L LCD monitor M170L is a 7" monitor, to which a camera (e.g. a rear view video
system) can be connected. It can be attached to the dashboard and is therefore suitable
for connecting to a rear view video system which allows the driver to see the space behind
the vehicle, for example, when parking.
5.1

Function description

A camera, which monitors the space to the rear, can be connected to the M170L LCD
monitor.
The LCD monitor can be mounted to the dashboard where it transmits the image of the
connected camera so that the driver is able to see the area behind the vehicle, e. g. when
parking.
5.2

Operating elements

The following control elements are located on the monitor:
No. in
fig. d, Designation
page 8
1 DAY/NIGHT
2 –
3 MENU
4 +
5 POWER
6

General information on the electrical connections

6.1 Laying cables
Note
I
As far as possible, use original openings or alternative openings for the connect-
ing cable duct, e. g. the paneling edges, ventilation grilles or blank panels. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to come out.
30
Description
Switches from day mode to night mode (reduced picture
brightness to prevent dazzling) and and vice versa.
Switches between two fixed values, regardless of the
brightness previously set.
Reduces the volume or other selected parameters
(brightness, contrast, colour tint).
Switches to setup mode (see chapter "Using the
LCD-monitor" on page 35).
Increases the volume or other selected parameters
(brightness, contrast, colour tint).
Switches the monitor on and off.
M170L