Waeco MagicSpeed HUD Instructions De Montage Et De Service page 29

Cleaning and caring for the display
All manuals and user guides at all-guides.com
7.4 Setting the warning speed
The warning speed is the speed above which the display emits a warning tone. You
can set the warning speed at one of eight levels: 30, 50, 70, 80, 90, 100, 120 and
130 km/h. "100" is set by default.
➤
Press the "
✓
The display switches to warning speed mode (fig. c, page 6).
✓
The set speed is displayed.
➤
Press the "▼" button to select the next speed up, or
➤
... press the "▲" button to select the next speed down.
➤
Press the "
✓
The display save the current setting.
7.5 Enabling and disabling the warning tone.
You can enable or disable the warning tone when the set speed is reached.
➤
Press the "
✓
The warning tone is enabled and disabled alternately.
✓
The speaker symbol in the display lights up.
8 Cleaning and caring for the display
Caution!
Do not use any sharp or hard objects for cleaning since they may damage
the display.
Caution!
Remove the cable before cleaning the display to prevent short circuiting.
➤
Clean the display with a soft, damp cloth from time to time.
9 Guarantee
The statutory warranty period applies. If the product is defective, please return it to
the WAECO branch in your country (see the back of the instruction manual for the
address) or to your dealer. For repair and guarantee processing, the following
documents must be sent along with the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
24
" button three times.
" to quit setup mode.
" button in display mode (fig. d, page 6).
MagicSpeed HUD