Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Locate the two (2) enclosed AA batteries.
Match the + and - marks with those in the
battery case, then insert them.
3.
Align the cover's keys with the case's holes and
press the cover back into place. The tab should
click when the cover is locked.
4.
Test the remote control by pressing any mode
key (e.g., TV). If the batteries are inserted
correctly, the LED (red light) blinks once.
NOTE:
When batteries need replacement, the remote
control ceases to operate. Replace the
batteries and the unit is restored to its full
functionality, complete with your favorite
settings.
IF YOU HAVE MORE THAN ONE SATELLITE
RECEIVER
Your remote control address is set at the factory to 0000
to control all of the functions on your Motorola satellite
receiver. However, if you have more than one satellite
receiver, you may want to prevent the remote control in
one room from affecting the satellite receiver in another
room. To prevent this kind of interference, you must
"pair" each remote control with each receiver by
assigning a new "address" to each combination. This
"address" assignment is made using your remote control
as follows:
1.
Turn on the TV.
2.
Press the SAT key to select the remote control's
SAT mode.
Press the Options key to display the Options
3.
screen on your TV.
4.
On the Options screen, use the
keys to highlight the Change System Settings/
System Setup option, then press ENTER.
5.
On the Systems Setting /Setup screen, use the
Installation Settings/System Settings option,
then press ENTER. (Applies to DSR 5xx, 207,
317 receivers.)
,
,
,
keys to highlight the Change
10
,
,
,
Publicité
Chapitres
Table des Matières
