Assembling Cleaner; Carton Contents - Hoover WindTunnel Manuel Du Propriétaire

1. Assembling cleaner

This cleaner was inspected and packaged carefully before being shipped from the factory. If you should happen to
need assistance during assembly or operation:
Visit us on-line at hoover.com to find the service outlet nearest you (click on the "Service" button) OR
Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR
Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.

Carton contents

1-1
A
STEP 1 Attach handle
1-2
A
Remove cardboard (A) and screws
from handle section. Discard card-
board.
1-5
Slide handle section onto back of
handle.
Push screws into holes on back of
handle.
Tighten screws securely with a
Phillips screwdriver.
Remove powered hand tool (some
models) from plastic bag and return
it to the tool storage area.
4
B
1-3
Open tool cover on cleaner body (B).
Remove powered hand tool (some
models).
D
C
B
A. Handle section
B. Cleaner body
C. Hose, cleaning tools and wands
(packed on cleaner)
D. Powered hand tool (some models)
Remove all parts from carton and
identify each item shown. Make sure
all parts are located before dispos-
ing of packing.
1-4
Make sure that the switch is in the
OFF position.