Replacing Agitator Brush Roll; Agitator Brush Roll - Hoover WindTunnel Manuel Du Propriétaire

3-20
C
E

Replacing agitator brush roll

Insert agitator through belt and
place belt in belt guide (C) on
agitator.
Should the agitator shield (D)
become dislodged while replacing
the belt or the agitator, reposition it
as shown noting the placement of its
belt guide (E).
The agitator brush roll
When to replace
When agitator brushes are worn, the
agitator should be replaced.
To check condition of brushes, dis-
connect cleaner from electrical
outlet. Move edge of a card across
bottom plate while turning agitator.
To maintain cleaning effectiveness,
replace agitator if brushes do not
touch card.
What to buy
When purchasing a new agitator, ask
for HOOVER part No. 48414-115.
3-24
Installing groomers
Lift off both old edge groomers and
slide new edge groomers into position
as shown.
Reposition bottom plate and secure
with 4 Phillips head screws.
3-21
G
D
Securing agitator
Grasp agitator firmly and fit it into
position by first sliding end opposite
the belt into the rectangular slot (F)
on side of cleaner.
Pull other side of agitator (G) into
place.
Turn agitator making sure belt is not
pinched between agitator and agita-
tor shield.
3-23
How to replace
Disconnect cleaner from electrical
outlet.
Remove bottom plate, belt and agita-
tor following directions in "The belt"
section beginning with Fig. 3-17.
Discard old agitator.
Continue following the directions in
"The belt" section to reposition belt,
new agitator and bottom plate.
Powered hand tool
(some models only)

Agitator brush roll

replacement
When agitator brush roll brushes are
worn, the brush roll should be
replaced. Ask for HOOVER part No.
48414-088.
3-25
How to replace
1. Remove tool from hose and turn it
so bottom faces up. Press the latch-
es on either side of tool and remove
bottom plate (A).
3-22
F
Replacing bottom plate
Reposition bottom plate and 4
Phillips head screws. Tighten
screws securely.
The edge groomers
When to replace
The edge groomers, located on both
sides of the nozzle, should be
replaced when they appear worn.
What to buy
When purchasing edge groomers,
ask for HOOVER part No.
39511-004.
How to replace
Disconnect cleaner from electrical
outlet.
Remove bottom plate as described in
"The belt" section (Fig. 3-17).
3-26
A
2. Unscrew the two Phillips screws
and remove belt guard (B).
B
Continued
11