Belt Replacement - Hoover WindTunnel Manuel Du Propriétaire

3-13
Reattaching filter door
The filter door is designed with a
"break-away" feature which allows it
to snap free if it is pushed open too
far.
To reattach, align hinges (L) of cover
with slots on sides of filter area.
Press door back into place.
3-15
Installing bulb
Pull old bulb straight out of socket.
Push new bulb straight into socket
until locked in place
Excessive force is not required.
3-17
How to replace
Disconnect cleaner from electrical
outlet.
Place handle in low position and
turn cleaner over so bottom side is
up.
Remove the 4 screws as shown with
a Phillips screw driver.
Lift off bottom plate (A).
10
Check agitator shield
Because your cleaner picks up so
well, we strongly recommend you
L
check for debris accumulation under
the agitator shield each time you
clean the filters.
Removing debris under the shield
will help maintain your cleaner's
excellent pick up and suction.
Remove debris as follows:
1. Disconnect cleaner from electrical
outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-17),
removing agitator (Fig. 3-18), and lift-
ing agitator shield (Fig. 3-20).
3. Remove any debris and replace
shield, agitator and bottom plate
(Figs. 3-20 to 3-22).
3-16
Replacing lens
Reposition lens and secure with the
two screws.
3-18
A
Removing belt
Remove agitator brush roll and used
belt.
Discard used belt.
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge
base type 912 bulb, HOOVER part
No. 27313-101.
3-14
Removing lens
Disconnect cleaner from electrical
outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.

Belt replacement

The belt on your HOOVER cleaner
causes the agitator to rotate and is
important for the effective operation
of the cleaner. The belt is located
under the bottom plate of the clean-
er and should be checked from time
to time to be sure it is in good con-
dition.
When to replace
Disconnect cleaner from electrical
outlet.
To check belt, remove bottom plate
as shown in "How to replace."
Replace belt if it is stretched, cut or
broken.
What to buy
To assure effective operation, use
only genuine HOOVER belts with
your cleaner. When purchasing a
new belt, ask for HOOVER part No.
38528-033.
3-19
B
Installing new belt
With lettering on outside of belt and
positioned as shown in box on (D),
slide new belt over motor pulley (B).
D