Cleaning The Brush Roll And Nozzle - Hoover ONE PWR SYSTEM FLOORMATE JET Mode D'emploi

CLEANING THE BRUSH ROLL AND NOZZLE

WARNING:
RISK OF PERSONAL INJURY - BRUSH ROLL MAY SUDDENLY RESTART. TURN POWER
SWITCH OFF AND REMOVE BATTERY BEFORE CLEANING OR SERVICING.
1
Place cleaner on tray.
2
Fill the included measuring cup with water
to max line (5 oz.). Pour water slowly into
rinse and storage tray.
THIS PRODUCT CONTAINS NO SERVICEABLE PARTS.
IF APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED, DAMAGED, LEFT OUTDOORS, OR
DROPPED INTO WATER, CALL CUSTOMER SERVICE AT 1-800-944-9200 PRIOR TO CONTINUING USE.
3
Recline and turn on to HIGH mode.
4
Run for 10-15 seconds until water is
extracted from tray. Repeat as needed until
brush roll is rinsed and debris is cleared
from nozzle. Replace the handle in the
upright position.
15
SECONDS
HIGH Mode
11