Panasonic WX-SE200DNP Mode D'emploi page 31

Table des Matières

Publicité

4
Pair the microphone to this product
Make sure that the [POWER] indicator on the extension receiver lights green, then
press for at least two seconds the [REG] button of the channel to which you want to
pair a microphone. Both the microphone and the extension receiver will enter pairing
mode and pairing will start. During pairing mode, the [PWR] indicator on the
microphone and the [REG] indicator of the channel whose [REG] button has been
pressed on the extension receiver will blinks orange.
If pairing is completed successfully, the [PWR] indicator on the microphone switches to
the normal status according to the remaining battery level (green, orange, or red), and
the [REG] indicator on the paired channel on the extension receiver lights green for
one second and then goes off.
● If pairing could not be completed successfully, the [PWR] indicator on the
microphone will blinks red.
Power indicator
This product
5
Unplug the microphone from the receiver
Unplug the cables connecting the microphone to the receiver.
If pairing has been completed successfully, the microphone starts transmitting audio.
Important
6
Place the battery cover back onto the microphone
Refer to the microphone manual for further details.
● The [REG] button is invalid if the channel to which microphone is paired and
if that microphone is in use. Turn the currently paired microphone power
OFF, then you can pair a different microphone to the channel that is already
in use.
● When a channel on the extension receiver is in pairing mode, all other
channels can still be used as normal.
● Paired microphones can be removed from the configuration/maintenance
PC installed the support software. Refer to the support software manual for
further details.
PUQX1040ZAV1_WX-SE200DNP_OI_en-fr.indb
Status indicator
Pairing indicator
Pairing button
31
31
2022/04/27
13:19:24

Publicité

Chapitres

Table des Matières
loading

Table des Matières