Fault Indications; Causes And Rectification Of Faults - CASO DESIGN TMCG25 Chef Touch Mode D'emploi

12.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program.
Press the
The device can be re-activated after the cool down phase.
E02 Technical error
A technical error has occurred. Press the
fault. Please contact our Customer Service.
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme. Press the
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.

12.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns
jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
caso TMCG25 Chef Touch
Description
button to acknowledge this fault.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
button to acknowledge this
button to acknowledge this fault.
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
Action
73