Troubleshooting; Safety Notices; Fault Indications; Causes And Rectification Of Faults - CASO DESIGN BMCG25 Mode D'emploi Original

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
E02
Technical Error: There is a technical error. Press
fault. Please contact the customer service.
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme. Press the Stop button to acknowledge this fault.
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.

15.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns
jerkily.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Description
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
, to acknowlege this
Action
68