Measurement Parameters - Chauvin Arnoux C.A 1864 Notice De Fonctionnement

English
4.4

MEASUREMENT PARAMETERS

The choice and setting of the measurement parameters is carried out by
successively pressing the MODE button:
■ EMI (see fig to right)
The emissivity percentage is adjusted using the
buttons qpaccording to the surface being
tested. (see table § 8.2).
Pressing the buttons qp briefly or holding
them down for a longer period gives smaller or
greater degrees of adjustment respectively. The
setting is held in memory after the instrument is
switched off and used during all successive
measurements, whatever the parameter used.
■ MAX (see fig to right)
When the trigger is pressed and held, the small
right-hand display indicates the maximum
temperature value measured whilst the trigger
is pressed.
The measurement set-up is held in memory
after the instrument is switched off, but not the
last maximum
instrument takes
measured upon the first press of the trigger
when switching on.
value recorded
into account
YES
since the
the value
Page 24
C.A 1864 – C.A 1866
NO
ε = 0.9
HOLD
234.8
EMS
ε = 0.9
HOLD
234.8
MAX
°C
°C
300