Power On/Off - Optelec ClearView C Mode D'emploi

Optelec
4. Operation
4.1. Introduction
When using the ClearView C, place your hands on the wrist support at the front
of the table for easy access to the Control Pad buttons and for steady table
movement.
The ClearView C is equipped with a wireless Control Pad, located between the
two wrist supports in the reading table. If the Control Pad is placed in the
reading table with the Optelec logo facing you, the ClearView C buttons for the
basic functionality are accessible.
To access the buttons for the advanced functionality, simply rotate the Control
Pad so five rectangular buttons are facing you.
The Basic Control Pad
4.2.
The Basic Control Pad is correctly placed in the reading table when the Optelec
logo is facing you, and three large buttons are on top of the Control Pad.

4.2.1. Power On/Off

In case the ClearView does not power on, make sure all cables are connected
and that the power switch, located at the left side of the camera box behind the
monitor, is in its ON position.
English
To power on both the system and monitor, press the orange
round On/Off button located next to the Zoom dial on th e
Control Pad. The ClearView C will start up in the same
viewing mode as when it was powered off.
It takes about 5 seconds for the camera unit to initialize
before it displays an image.
ClearView C
19