Cleaning And Maintaining; Changing The Bag - Rowenta SILENCE FORCE EXTREME Compact RO56 Serie Mode D'emploi

Masquer les pouces Voir aussi pour SILENCE FORCE EXTREME Compact RO56 Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

CLEANING AND MAINTAINING

The air we breathe contains particles that may be allergens:
mite larvae and droppings, mould, pollen, smoke and animal
residues (hair, skin, saliva, urine). The smallest particles
penetrate deep into the respiratory system where they can
cause inflammation and lung impairment.(H)EPA filters (High
Efficiency Particulate Air) are used to filter out the smallest
particles. With the (H)EPA filter, the air released back into the
room is healthier than the air that is vacuumed.
IMPORTANT Always switch off and unplug your
vacuum cleaner before servicing it.
1 • Changing the bag
The change bag light tells you that the bag is full or
saturated. If you notice that your vacuum cleaner is not
working as well as it should be, turn the power up to
maximum and hold the lifted nozzle above the floor. If the
light stays red, replace the bag.
a) If your vacuum cleaner is fitted with a Wonderbag* (18a) :
IIMPORTANT Wonderbag* UNIVERSAL bags are
available from retail outlets and at Approved Service
Centres.
IMPORTANT Wonderbag* COMPACT bags can't be
used on this appliance. Using them could damage
the vacuum cleaner and may invalidate the
appliance guarantee.
Open the cover to your vacuum cleaner (Fig.14).
Remove the bag support from the bag compartment
(Fig.15).
Remove the Wonderbag* bag from the bag support (Fig.16).
Throw the Wonderbag* bag away (Fig.17).
Place a new Wonderbag* bag in the bag support using its
ring (Fig.18).
Place the bag support in the bag compartment and fit the
bag inside the compartment (Fig.19).
Make sure that the bag is correctly positioned before closing
the cover.
b) If your vacuum cleaner is fitted with a synthetic (textile)
bag* (18b) :
Synthetic bags* (ref.RS-RT2274) are available from
Approved Service Centres.
Open the cover to your vacuum cleaner (Fig.14).
Remove the bag support from the bag compartment
(Fig.20).
Remove the synthetic bag* from the bag support (Fig.21).
Open the synthetic bag* using the zip (Fig.22) then empty it
into a dustbin (Fig.23).
Check that the zip is properly closed once more before
putting the bag back in again (Fig.24).
Place the synthetic bag* on the bag support using its
cardboard holder (Fig.25), place the bag support in the bag
compartment and fit the bag inside the compartment
(Fig.26).
Make sure that the bag is correctly positioned before closing
the cover.
* Depending on models: either equipment specific to cer-
tain models or available as an optional accessory.
IMPORTANT Never operate the vacuum cleaner
without a bag.
For your peace of mind your vacuum cleaner is fitted
with a safety system which tells you that the bag is
inside (the cover won't close unless you've put the
bag in).
2 • Changing the (H)EPA* filter
cassette (ref. ZR 0029 01*) (for all
appliances fitted with a Wonderbag*
bag)
IMPORTANT Replace the filtration system once a
year.
The (H)EPA filter cassette ref. ZR 0029 01* is available from
all retail outlets and at approved Service Centres.
Open the cover to your vacuum cleaner (Fig.14). Remove the
bag support from the bag compartment (Fig.15), then
remove the (H)EPA* filter cassette (Fig.27) and throw the
cassette into a bin (Fig.28).
Fit the new (H)EPA* filter cassette (ref. ZR 0029 01*) into its
compartment (Fig.29)
Put the bag support back into the compartment (Fig.19).
Make sure that the (H)EPA* filter cassette is correctly
positioned before closing the cover.
3 • Cleaning the HEPA* filter cassette
(ref ZR0052 01*) (for appliances which
come with a synthetic bag*)
IMPORTANT! This cleaning procedure is only for
(H)EPA filter cassettes ref. ZR0052 01*
The (H)EPA* filter cassette ref.ZR0052 01* is available from
all retail outlets and at approved Service Centres.
Open the cover to your vacuum cleaner (Fig.14). Remove the
bag support from the bag compartment (Fig.20), then
remove the (H)EPA* filter cassette (Fig.30).
Tap the (H)EPA* filter cassette above a dustbin (Fig.31).
Put the (H)EPA* filter cassette (ref. ZR005201*) back in its
compartment (Fig.32).
Put the bag support back with the synthetic bag* in the bag
compartment.
Make sure that the (H)EPA* filter cassette is correctly
positioned before closing the cover.
IMPORTANT Never use the vacuum cleaner without
a (H)EPA filter cassette.
For your peace of mind your vacuum cleaner is
fitted with a safety system which tells you that the
(H)EPA cassette filter is in place (the cover won't
close unless you've put the (H)EPA) filter cassette
in.
9
EN

Publicité

Table des Matières
loading

Table des Matières