Aqua Medic SN Blue Mode D'emploi page 8

As soon as the Nitrate filter is placed in the correct position and all connections are ready, the
water flow can be started. The inlet is marked by "IN" (10), the outlet by "OUT" (12). Connection
No. 11 is not necessary. Before you open the Sulphur-Nitratereductor SN Blue after filling, you
have to let off the water from the lid. This is done most simply by hanging the hose of the inlet
(IN) in a lower placed bucket or into the drain. Since the inlet is extended inside, the reactor runs
dry automatically up to this point.
Please don't pull on the cable to open the lid but hold under the lid's edge.
The back flow into the aquarium or the filter tank should be directed to a well-flushed place in
order to mix it immediately with the aquarium water. The drip counter (14), included in delivery, is
used for a safe mounting of the hose as well as for controlling the flow.
6. Maintenance
The Aqua Medic Hydrocarbonate (coarse grain) is consumed by the chemical reaction and has to
be refilled from time to time. Furthermore, it should be replaced completely regularly since the
grain size decreases and thus flow and circulation drop. The same applies for the sulphur beads.
Also the flow rate should be checked regularly.
The pump should be cleaned occasionally. To do so, the cap of the pump housing (8) has to be
taken off. One hand holds the pump inlet and the other one the pump outlet, then the cap has to
be drawn to the top. Take care not to tilt since otherwise, the ceramic axle might break.
7. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase
on all material and manufacturing defects of the device. Incidentally, the consumer has legal
rights; these are not limited by this warranty. This warranty does not cover user serviceable parts,
due to normal wear & tear ie: impellers or drive wheels etc. The original invoice or receipt is
required as proof of purchase. During the warranty period, we will repair the product for free by
installing new or renewed parts. This warranty only covers material and processing faults that
occur when used as intended. It does not apply to damage caused by transport, improper handling,
incorrect installation, negligence, interference or repairs made by unauthorized persons. In case
of a fault with the unit during or after the warranty period, please contact your dealer.
All further steps are clarified between the dealer and AB Aqua Medic. All complaints and
returns that are not sent to us via specialist dealers cannot be processed. AB Aqua Medic is
not liable for consequential damages resulting from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
- Technical changes reserved – 04/2019
8