Install The Battery - Hach 2100Q Manuel D'utilisation De Base

Figure 2 2100Q and 2100Qis components
1 2100Q or 2100Qis turbidimeter
2 Carrying case
3 User manual, Quick reference guide
and CD-ROM
4 Oiling cloth
5 1" sample cell (10 mL) with cap (pk/
6)
Installation
Personal injury hazard. Only qualified personnel should conduct the tasks
described in this section of the manual.
6 English
All manuals and user guides at all-guides.com
6 Silicone oil
7 20, 100 and 800 NTU StablCal
calibration standards
8 AA alkaline batteries (pk/4)
9 StablCal 10 NTU verification
standard
C A U T I O N

Install the battery

W A R N I N G
Potential fire hazard. Use only alkaline or nickel metal hydride batteries (NiMH) in
the meter. Other battery types or incorrect installation can cause a fire. Never mix
battery types in the meter.
The battery compartment is not waterproof. If the battery compartment becomes
wet, remove and dry the batteries and thoroughly dry the interior of the
compartment. Check the battery contacts for corrosion and clean them if
necessary.
When using nickel metal hydride (NiMH) batteries, the battery icon will not indicate
a full charge after freshly charged batteries have been inserted (NiMH batteries
are 1.2 V versus 1.5 V for alkaline batteries). Even though the icon does not indicate
complete charge, 2500 mAH NiMH batteries will achieve 90% of instrument
operation lifetime (before recharge) versus new alkaline batteries.
The meter can be powered with AA alkaline or rechargeable NiMH
batteries. To conserve battery life, the meter will power off after 10 minutes
of inactivity, the backlight powers off after 30 seconds. This time can be
changed in the Power Management menu.
Note: Rechargeable batteries will only be recharged with the USB/power module.
Refer to the module documentation for further information.
For battery installation refer to
1. Remove the battery cover.
2. Install 4 AA alkaline or 4 AA nickel metal hydride (NiMH) batteries.
Make sure that the batteries are installed in the correct orientation.
3. Replace the battery cover.
N O T I C E
N O T I C E
Figure 3.