Removing Transport Safety Packaging - Electrolux EDE 37100W Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the machine.
• To keep vibration and noise to a mini-
mum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deeply
carpets, strips of wood or similar. This
might cause heat built-up which would
interfere with the operation of the appli-
ance.
Important! The hot air emitted by the
tumble dryer can reach temperatures of up
to 60°C. The appliance must therefore not
be installed on floors which are not resistant
to high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Warning! Should the appliance be
moved, it must be transported
vertically.
Warning! The appliance must not be
installed behind the lockable door, a
sliding door or a door with a hinge on
the opposite side to that of the
appliance.
REMOVING TRANSPORT SAFETY
PACKAGING
Caution! Before use all parts of the
transport packaging must be removed.
All manuals and user guides at all-guides.com
1. Open loading door.
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
FITTING THE VENT HOSE
To simplify the installation, there is a choice
of vent outlets: one at the back, the others
in the left and right-hand side. Connect the
hose to whichever is the more convenient
by pulling the ring nut (A) from the vent out-
let at the back, screwing it on to the hose
and pushing it firmly back into place. The
unused vents should now be sealed with
the special snap covers provided.
electrolux 11

Publicité

Chapitres

Table des Matières
loading

Table des Matières