Installation; Appliance Positioning; Removing Transport Safety Packaging - Electrolux EDE1074PDW Notice D'utilisation

Energy consumption
Annual energy consumption
Energy efficiency class
Power consumption
1) With reference to EN 61121. 7 kg of cotton and a spin speed at 1000 rpm.
2) Energy consumption per year in kWh, based on 160 drying cycles of the standard cotton programme at full and
partial load, and the consumption of the low-power modes. Actual energy consumption per cycle will depend on
how the appliance is used (REGULATION (EU) No 392/2012).

INSTALLATION

Important! The appliance must be moved
in vertical position for transport.

APPLIANCE POSITIONING

• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the machine.
• To keep vibration and noise to a mini-
mum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deeply
carpets, strips of wood or similar. This
might cause heat built-up which would
interfere with the operation of the appli-
ance.
Important! The hot air emitted by the
tumble dryer can reach temperatures of up
to 60°C. The appliance must therefore not
be installed on floors which are not resistant
to high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Warning! Should the appliance be
moved, it must be transported
vertically.
1)
kWh/cycle
2)
Left-on mode
Off-mode
4,25 kWh
614,56 kWh
C
0,70 W
0,70 W
Warning! The appliance must not be
installed behind the lockable door, a
sliding door or a door with a hinge on
the opposite side to that of the
appliance.
REMOVING TRANSPORT SAFETY
PACKAGING
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door.
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
electrolux 15