Clean Operating Screen And Housing; What To Do If - Electrolux EDE 37100W Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lime in the water or cleaning agents
may form a barely visible lining on the
inside of the drum. The degree to
which the laundry has been dried is
then no longer detected reliably. The
laundry is damper than expected when
removed from the dryer.
Use a standard domestic cleaner (e.g.
vinegar-based cleaner) to wipe down
the inside of the drum and drum ribs.

WHAT TO DO IF ...

Problem
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
CHANGING THE BULB FOR INTERIOR
LIGHTING
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force cen-
tre.
All manuals and user guides at all-guides.com
CLEAN OPERATING SCREEN AND
HOUSING
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the START/
PAUSE button?
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at instal-
lation site differs from standard
setting of machine.
Filter not in place.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the
operating screen and housing.
Remedy
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Close loading door.
Press the START/PAUSE but-
ton again.
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean fluff filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum
and drum ribs.
Re-programme standard set-
ting for degree of drying (see
'Programming options' chap-
ter).
Install filter into place.
Select time programme or
higher drying level (e.g. EXTRA
DRY instead of CUPBOARD
DRY ).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
Warning! When the appliance is
switched on, the interior lighting
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
electrolux 9

Publicité

Chapitres

Table des Matières
loading

Table des Matières