Publicité
Les langues disponibles
Les langues disponibles
Introduction
The POWER PEAK 1 PLUS is designed for fast-charging and discharging NICD and NIMH
battery packs consisting of 4 to 7 cells.
When the pack is fully charged the process is terminated by the Delta Peak method.
The unit is designed for use with a 12 V lead-acid battery or a powerful well stabilised mains
PSU rated at 12 V or 13.6 V.
Safety notes
-
If the charger is not to be used for a protracted period, disconnect it from the power
source and remove any battery packs connected to it.
-
Be sure to keep the cooling slots unobstructed to provide good air circulation - don't
stand the charger on a carpet or felt surface.
-
Do not set up the charger and batteries on a flammable surface, and never leave the
unit operating unsupervised.
-
Protect the unit from damp.
-
Take care to maintain correct polarity at all connections and outputs.
-
Avoid short-circuits.
-
Don't subject the charger to direct sunshine, and do not cover it.
-
Do not charge batteries which are already hot; allow them to cool down to ambient tem-
perature before recharging.
-
Use only packs of fast-charge cells which have been properly balanced (equal state of
charge).
-
Packs must consist of cells of the same make, type and capacity.
-
Do not wire two packs together in parallel for charging.
-
The unit is only suitable for use with rechargeable batteries.
-
Set charge currents within the maximum rated capacity of the cables and connectors
attached to the battery pack.
-
Never connect any charger output to the input.
Specification
Operating voltage:
Nominal battery voltage:
Charge current:
Automatic charge termination: Delta Peak process
Trickle charge current:
Discharge current:
Discharge termination:
Protective functions:
Fuse:
Dimensions:
Weight:
All manuals and user guides at all-guides.com
Operating instructions
POWER PEAK 1 Plus
approx. 11 V ... 15 V DC
12 V lead-acid battery or a powerful well stabilised mains
PSU (do not use a car battery charger!)
4.8 V ... 8.4 V
1 A ... 1.5 A for 4-cell / 5-cell batteries
1 A ... 4.5 A for 6-cell / 7-cell batteries
approx. 180 mA
approx. 0.8 A ... 1.2 A, depending on cell count
automatic, at approx. 0.8 V / cell
Polarity protection at input and output,
short-circuit protection on output
10 A car fuse
approx. 140 x 110 x 55 mm
approx. 350 g
7
Order No.
8424
Publicité
