Navigation And Parameters Modification Operations - AERMEC VXT Mode D'emploi

Navigation and parameters modification operations

MENU selection page:
Setpoint
Maintainer
Manufactory
Clock
DEFAULT page displayed:
09/07/09
Swicht
Mode
Unit on
09/07/09
Swicht
Mode
Unit on
09/07/09
Swicht
Mode
Unit on
09/07/09
Swicht
Mode
Unit on
36
L1
12:28 P0
ON
Cooling
12:28 P0
ON
Cooling
12:28 P0
Cooling
12:28 P0
on
ooling
Pass to another menu
To pass from one menu to another, it is necessary to activate
the menu selection screen. This display can be activated by pres-
sing , or
Prg
Esc
Note: if the menu selection screen is being displayed, another
press of the ESC key will take the user back to the 0 page of the
MAIN menu (default display).
Pass from one page to another in the same menu
To navigate through the pages of a menu
the and arrow keys must be used
Note: Some pages do not contain parameters that can be
modified, but only parameters that can be displayed. Therefore,
in some pages it will not be possible to perform the procedure
to modify the displayed parameters (to find out which are the
parameters that can be modified on every page, refer to the
following tables).
Selecting and modifying a parameter
During display of the pages, the cursor flashes in the top left
corner of the display. To select a parameter present in the page,
press the key
Note: The cursor will shift onto the field of the first parameter
that can be modified that is contained in the page. Use the
arrow keys to make the modification. Pressing the ENTER key
again (the same used previously) will confirm the modification
made on the parameter (if it has been modified) and will scroll
to the next parameter. If there is no successive parameter the
last parameter on the page has been reached, pressing ENTER
again will make the cursor go back into the upper left corner
of the display, indicating exit from the modification mode and
return to display mode.