Preconfiguring The Heat Pump Heating System; Menu - Dimplex WPR 2006 Notice De Montage Et Mise En Service

5

5 Preconfiguring the Heat Pump Heating System

The preconfiguration informs the controller about which
components are connected to the heat pump heating system.
Preconfiguration must be carried out before the system-specific
settings in order to show or hide menu items (dynamic menus).
The following table shows not only the menu structure and
explanations in the right-hand

5.1 Menu

You can access the preconfiguration menu by:
Simultaneously pressing (approx. 5 seconds) the button
combination (ESC) and (MENU).
Exit the preconfiguration via the button (ESC).
The following presettings must be carried out:
E-6
All manuals and user guides at all-guides.com
column, but also the
Preconfiguration of all system components for
dynamic menu structuring
Monovalent (heat pump as sole heat
generator)
Has the system got a heating circuit 2 with a
controllable mixer?
Which type of room cooling is being carried out?
Is DHW heating carried out by the heat pump?
Is a sensor or thermostat used to regulate DHW
heating?
corresponding setting ranges. Values in bold print indicate the
factory settings.
The factory settings in the "Preconfiguration" menu correspond
to the integration diagram for a mono energy heat pump
(normally an air-to-water heat pump) with 1 compressor and a
heating circuit without DHW heating using the heat pump.
Abbreviations:
HP Heat pump
AW HP Air-to-water heat pump
BW HP Brine-to-water heat pump
WW HP Water-to-water heat pump
Setting range
Monovalent
No
Yes
Dynamic
Silent
No
Yes
Sensors
Thermostats
Display
Always
Always
Only with
heating circuit 2
Always
Sensor only without
heating circuit 2