Burg Wächter secuENTRY easy PINCODE Guide De Montage page 34

All manuals and user guides at all-guides.com
secuENTRY easy keypad installation
The keypad is only included in secuENTRY easy Pincode and
secuENTRY easy Fingerprint sets.
Attention! Please remember that the keypad should not be attached
to the door itself, otherwise it would transmit shocks when the
door is being shut. The membrane affixed to the keypad rear side
should not be sealed with glue and / or any other substance under
any circumstances! Exchange of air must also be possible after the
installation!
• Determine the installation place for the keypad. For that purpose, enter
the opening code (e. g. PIN code, fingerprint, ...) at the desired mounting
place and check whether the lock opens.
• Place the keypad correspondingly.
You can then decide whether you want to glue the wall holder directly on
the wall or whether you prefer having it screwed on. The slotted holes in the
wall holder provide for an exact alignment.
If you decide for gluing the wall holder, please be sure to provide for clean
surfaces free from fat, oil and silicon films and any other impurities. Remove
completely the protective film from the included adhesive pads, attach all
the pads on the wall holder and then press the whole firmly to the required
position. When mounting in colder temperatures, please remember that
the full adhesive force cannot be achieved before 72 hours in 20 °C, with
warmth accelerating the process (e. g. in 65 °C, the full adhesive force will
be achieved in one hour).
When gluing the holder plate on the colour sight protection film, the above
described conditions relating to cleanliness of surfaces and firmness of the
adhesive pad should be observed.
To provide for a bubble-free application of the colour sight protection film,
please proceed as follows:
• Pour some water with a couple of drops of dishwashing detergent into a
glass, stir it cautiously free of foam, and then use it to moisture gently the
surface, on which the film is to be applied.
• At an edge, pull off the white protective sheet from 1 cm of film and
straighten it out. To change the position, lift this surface carefully and
attach it again as required.
• Then swipe the adhesive film, e. g. with a plastic spatula, out from the
contact surface in the direction of protective sheet still attached.
36 | English
Attention! Do not use m
• Slide the keypad in from
• Perform a function test
• Remove the housing co
• Pull the battery compar
secuENTRY easy
locking peg of the mou
into the keypad housin
keypad is protected aga
door open. For this pur
a valid opening code (e
fingerprint, ...).
Battery replaceme
the 2 screws (Tx 8).
replace the batteries.
When inserting the n
the correct polarity a