Burg Wächter secuENTRY easy PINCODE Guide De Montage page 31

Please read these Installation Instructions carefully before the assembly and
then store them at a safe place.
The cylinder has a special detent system, offering you a possibility of using
the cylinder for doors with a thickness up to 118 mm (59 / 59 mm, measured
at the central detent bolt). No prior adjustment is necessary.
Attention: Be careful to not bang the knob anywhere, as the knob
can break in such case. The lock should not be greased or oiled
An incorporated locking screw in each knob is to fix the rotary knobs.
Attention: Never pull the inner knob completely from the shaft, as
this might cause damage to the electronics! The locking screw,
which ensures the detent on the shaft, may be loosened only lightly
and it always remains in the plastic knob, providing protection
against pulling it out.
Outer side
Outer knob
Remark
The base size of the cylinder is 30 mm per side. When delivered, the cylinder
is completely collapsed (the smallest door thickness). Before you insert the
cylinder into the door, you should adjust it to your door thickness.
When installing the cylinder, proceed as follows:
1 Take a rough measurement of the door thickness (incl. fittings)
2 Pull the outer knob from the shaft, move the inner knob over the
secuENTRY easy secuENTRY easy
All manuals and user guides at all-guides.com
Installation Instructions for secuENTRY easy cylinder
Cover Adapter 2
detent system (spacing 2.85 mm) to the required dimension.
Inner side
Inner knob
Adapter 1 Detent bolt
Schematic
illustration of
the mounted
cylinder including
the two adapters
Locking screw
for fixation onto
the shaft
English | 33