BH FITNESS LK500IC Manuel Du Propriétaire page 15

STEP 4. FASTEN HANDLEBAR
Refer to the following figure, put the Handlebar
(A9) onto the Handlebar Post (A8), and fasten
them through Flat Washer (11) with Quick Handle
(A10).
STEP 5. FASTENING THE SLIDER AND SEAT
Affix the Seat Slider (20) to the Seat Post (A19).
From below the Seat Post, use the Washer (11) and
Quick Handle (A10) to screw into the bottom of the
Seat Slider (20) to secure. Slide the Seat (21) onto
the post of the Seat Slider (20) and tighten with the
13 mm wrench provided. Install a second Quick
Handle (A10) by Screwing into the Seat Support
Tube to secure the Seat Post (A19).
STEP 6. ATTACH THE CONSOLE
First unscrew the 2 Screws (80) from the Handlebar
(A9). Mount the Console Bracket (58A) onto the
Handlebar (A9) with the screws you just removed.
Next take out the Screw (79) on the back of the
Console (58) and set aside,. Now slide the back
cover off of the Console (58) and install the
included batteries. Replace the back cover. Slide
the Console (58) onto the Console Bracket (58A)
and secure the Console (58) with Screw (79) on
the back of the Console (58). After the Console
(58) is secure, connect the Upper Sensor Cable
(81) to the cable coming from the Console (58).
15