PIEPS PRO BT Instructions page 19

Detailed SCAN & victim selection
Press the button SCAN (1E) while in search mode.
The PIEPS PRO BT scans the entire receiving range
and ends with indicating the direction and distance
to the first victim.
Use MARK (1D) to scroll through the closest 3
victims. The selected one is encircled (2J) – follow
the direction/distance reading to approach it. The
MARK function is not available in this mode.
Press SCAN to exit the Detailed SCAN mode and to
return to regular search mode.
4.9.6 Analog mode
The analog mode can be used for specific search strategies as well as for demo reasons (coupling positions).
Disabled by default, the feature can be enabled in the PIEPS APP device manager.
Press the button SCAN (1E) for 3 seconds while in search
mode. The analog mode starts with biggest range.
Use SCAN to reduce range. Use MARK to increase range.
Press SCAN for 3 seconds to exit the analog mode and to
return to regular search mode.
4.9.7 TX600 mode
The TX600 mode allows detecting the PIEPS TX600 – this is a mini transmitter for
dogs/equipment that works with 456 kHz.
Start TX600 mode: Press the buttons MARK (1D) and SCAN (1E) simultaneously for 3 seconds
while in search mode. You see a "TX" indicated on the display (2M). Follow the search phases
as usual but use a reduced search strip width of 20 m. MARK can also be used as usual, SCAN
and analog mode is not available in TX mode.
Exit TX600 mode: Press MARK and SCAN simultaneously again for 3 seconds. Alternatively,
switch to send mode and then back to search mode. The "TX" indication disappears and the
PIEPS PRO BT is receiving 457 kHz signals again.
NOTICE The recommended search strip width in TX600 mode is 20 m.
Manual PIEPS PRO BT/POWDER BT | Firmware v1.0 | 08/2018 18 / 22